Case Studies

Installation of a Rinnai tankless water heater system including full gas line integration, venting configuration, and system mounting. The team worked through tight basement conditions to properly route exhaust and ensure code-compliant installation.

This Pembroke project was all about getting a homeowner back up and running after their old system failed. We replaced the existing furnace and AC with a brand-new, high-efficiency setup, giving them a reliable solution for both heating and cooling moving forward.

This project was all about upgrading a home’s water heating system to keep up with both the main house and a new addition. For this returning customer, the team worked on installing and tying in an updated system that could handle increased demand while staying efficient and reliable.

This Merrimack, NH project was a full system upgrade, replacing an outdated heating and cooling setup with a new, high-efficiency Ducane unit. The team handled everything from removal of the old equipment to installing and dialing in the new system.

At this condo in Hudson, NH, the washer had sewage backing up into it—a clear sign the drainage system wasn’t working the way it should. We got into the space, traced the issue through the existing lines, and made the necessary repairs to restore proper flow.

This project was all about helping a returning customer stay ahead of the summer heat with a smart upgrade to their home in Hollis, NH. We installed a mini-split system to give them efficient, targeted cooling where they needed it most. From running clean exterior line sets to securing and connecting the outdoor condenser, every step was handled with precision to ensure long-term performance and reliability.

This install in Amherst, NH was all about efficiency, teamwork, and delivering a high-performance heating upgrade without the typical downtime. We installed a new Viessmann heating system, known for its reliability and energy efficiency, and approached the job a little differently than usual.

This one was for a returning customer who had their water heater fail in the basement, so we jumped in to get them back up and running as quickly as possible. We replaced the unit, handled a few smaller repairs along the way, and made sure everything was dialed in before wrapping up. It’s always a good feeling helping out someone we’ve worked with before and getting their system back on track.

This one was part of a fresh bathroom renovation, and we got to jump in early to build everything out behind the walls. We installed the new valve assembly, ran clean copper lines, and set everything up so it’s ready for a smooth finish once the space comes together. There’s something satisfying about seeing it at this stage knowing it’s going to turn into a brand new bathroom.

The team focused on installing the shower fixtures, carefully setting and securing each component to ensure everything was aligned, watertight, and built to last. From tightening connections behind the wall to mounting the trim and controls, every detail mattered to make sure the system performs as good as it looks.